Notes on the instruction manual
14
NOTE
The devices with integrated bus coupler have been prepared for installing in
flush-mounted boxes in connection with the corresponding mounting plate.
Ensure that there is sufficient distance between movement detector and heat
sources such as lighting, heaters, etc., since these devices can cause incorrect
switching.
To install the device, perform the following steps:
1. Screw the support ring to the flush-
mounted box.
2. Attach the cover frame (not included
in scope of delivery).
3. Connect the bus line with the bus
connection terminal [1] (Chapter 6.2
“Electrical connection“ on page 15).
– Observe the correct polarity!
