CONTROL PANEL
888.226.4469
3
2
ContoursBaby.com
ATTACH CHANGING PAD TO SECURE SURFACE
Attach the changing pad to the changing surface by using
the following instructions:
1. Use a screwdriver to attach the anchoring strap to the back of
the changing table or dresser or to the wall.
2. Periodically check the anchoring strap to ensure it remains
tight and securely attached to the changing table or dresser.
3. To remove the pad from the changing table or dresser,
unscrew the mounting screw and store in a safe place.
This pad includes two anchoring straps, one on either side of the
changing pad, for fl exibility. Only one anchoring strap needs to
be attached to a dresser, changing table or wall. Tuck the other
anchoring strap underneath the changing pad.
SECURELY RESTRAIN BABY ON CHANGING PAD
How to properly use the restraint system:
Align the restraint strap over baby’s
abdomen and buckle securely, adjusting and
tightening for a snug fi t. Always use enclosed
restraint strap and keep one hand on baby
when using this changing pad.
MAIN Power On / Off,
Located Under Control Panel
Room Darkness Sensor
Brightness Indicator
Brightness
On Indicator*
Lights On / Off
Lights with Motion Sensors
OPERATION
Function Action
Turn MAIN power on or off
Slide the on/off switch located beside
the battery door, underneath the control
panel.
Turn MAIN power off if not using pad
for extended period of time to conserve
battery life.
Turn lights ON - Night Mode
Pad will sense when baby is placed on pad
(MAIN power on)
-
Lights turn ON automatically
-
Lights turn OFF automatically, about 45 seconds after baby is removed
(Press ‘Lights On/Off’ button to turn off sooner)
Turn lights ON or OFF - Day Mode
Press “On/Off” button
(MAIN power on)
-
Lights turn OFF after about 45 seconds
-
Or press button again to turn OFF
Adjust brightness
Press “Brightness” button
(low / medium / high)
(default is “medium” setting)
BATTERY INSTALLATION
To prevent battery leaks, which can burn skin and eyes:
• Remove batteries when storing product for a long time.
• Dispose of used batteries immediately.
• Always replace the entire set of batteries at one time.
• Never mix old and new batteries, or batteries of
different brands or types.
l
CAUTION
1. Unscrew the battery door on the bottom of the
electronic unit, with a Phillips screwdriver.
2. Insert 3 new “AA” batteries as shown.
Replace battery door and tighten the screw.
+ -
-
+
+ -
If lights automatically turn on during the day or in a bright room,
ensure that nothing is blocking the room darkness sensor.
*Flashing red light indicates room is dark enough for lights
to automatically turn on when baby is placed on pad.
