Continental Fireplaces CEFL50B, Installation And Operating Instructions Manual

Page: 9 / 20

9
W415-1290 / 07.13.15
EN
4.0 FINISHING
!
WARNING
POWER SUPPLY SERVICE MUST BE COMPLETED PRIOR TO FINISHING TO AVOID
RECONSTRUCTION.
HEAT VENTS AND AIR OPENINGS CANNOT BE COVERED IN ANY CIRCUMSTANCES.
4.1 GLASS DOOR REMOVAL
A. Place one hand on the glass panel and remove the 2 screws from the top of the appliance.
B. Carefully, lift the door up and away from the appliance.
!
WARNING
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
THE DOOR LATCHES ARE PART OF A SAFETY RELIEF SYSTEM AND MUST BE PROPERLY
ENGAGED. DO NOT OPERATE THE APPLIANCE WITH LATCHES DISENGAGED.
FACING AND/OR FINISHING MATERIALS MUST NOT INTERFERE WITH AIR FLOW THROUGH AIR
OPENINGS, LOUVRES OPENINGS, OPERATION OF LOUVRES OR DOORS OR ACCESS FOR
SERVICE. OBSERVE ALL CLEARANCES WHEN APPLYING COMBUSTIBLE MATERIALS.
BEFORE DOOR IS REMOVED TURN THE APPLIANCE OFF AND WAIT UNTIL APPLIANCE IS COOL TO
THE TOUCH. DOORS ARE HEAVY AND FRAGILE SO HANDLE WITH CARE.
75.1
GLASS PANEL
4.2 CRYSTAL / PEBBLE MEDIA INSTALLATION
The appliance comes with the log bed already installed, to switch media follow these steps:
The glass front must be removed and the appliance must be mounted in
its fi nal location before crystals or pebbles are installed.
A. CLEAN CRYSTAL MEDIA: Crystal media may have a fi ne oil
residue that needs to be cleaned prior to installation. Clean the
crystal with mild dish soap, drain, rinse thoroughly and dry before
placing into the tray.
B. Remove the 2 log bed screws on either end of the appliance and
lift the log bed out.
C. Place the shelf onto the front of the appliance opening
D. Carefully place crystals or pebbles into the bottom tray on the front of the appliance as illustrated.
Apply an even layer from side to side. Re-ecure the glass panel.