CONTINENTAL EDISON CEBS1N, Instruction Manual

Page: 45 / 48

45
Before first use
Before first use, it is recommended to operate the kettle for 2 or 3
times following the instructions below , this will remove any dust or
residues remaining from the manufacturing process.
• Take up the kettle from the base before filling.
• To fill the kettle, open the cover by pulling the lid handle inwards,
then fill to the desired level (MIN0. 5L-MAX.1.7L), close the lid by
pressing it down until it clicks into place.
• Plug the power supply cord into the main, press the ON/OFF switch,
the power indicator lights up.
• When the water has boiled the kettle will automatically switch itself
off, you can stop the boiling process at any time by lifting the On/
Off switch. The power indicator will go out.
Cleaning
• First read the instructions in the section titled “IMPORTANT
INSTRUCTIONS”.
• Always disconnect the kettle from electrical outlet before cleaning.
• Before cleaning make sure the kettle is cold enough.
• Empty the kettle, Clean the exterior surface of the kettle with a
clean, damp cloth to preserve its original highly polished finish. Dry
and polish with a soft cloth.
• Do not use abrasive cleansers or scouring agents of any kind inside
or on the exterior of the kettle.
• Open the lid, lift out the filter, rinse the filter under warm water and
brush off any impurities.
• Only use the dry cloth to wipe the base of the kettle.
• Avoid wetting the electrical parts.
• Do not immerse the kettle or power base in water or other liquid,
and make sure the electrical kettle socket is kept dry.
• Refitting is the reverse of removal.