1500W DMX smoke machine with HF remote control and Timer
Page 6
English
4-3 : The control panel
The control panel features 6 buttons:
Function
,
Timer
,
Up
,
Down
,
Volume
et
Manual
.
The display will indicate
once the
preheating process has been completed, W meaning the
device is waiting for information from the remote control.
1 -
Once the display indicates
, press
until it indicates
.
This function allows you to use the
buttons
to adjust the interval between smoke projections (from 1
to 200 seconds).
2 -
Once the display indicates
, press
twice
. The display will then indicate
. This function allows you to use the
buttons to adjust the duration of smoke
projections (from 1 to 200 seconds).
3 -
Once the display indicates
, press
three times
. The display will then indi-
cate
. This function allows you to use the
buttons to configure the smoke quantity in
Timer mode (from 1 to 100%). Press the
button
to deactivate the Timer mode. Press it again to activate
it.
4 -
Once the display indicates
, press
four times
. The display will then indicate
. This function allows you to adjust the
smoke output in Volume mode, via the
but-
tons. Press
to deactivate the Volume function.
Press again to reactivate.
5 -
Once the display indicates
, press
five times
. The display will then indicate
. This function allows you to configure
the DMX address via the
buttons.
6 -
Once the display indicates
, press
six times
. The display will then indicate
. This function allows you to activate or
deactivate the remote control via the
but-
tons.
7 -
Once the display indicates
, press
and hold
to force the smoke output at 100%.
The smoke output will be deactivated as soon as you
release
.
8 -
Your Smotec1500 features an optical level sensor.
The pump will automatically stop if the fluid level gets
too low, the display will then indicate
.
Pour more fluid into the tank and press
until
disappear.
9 -
If you do not wish using the optical sensor,
press
seven times
as the display indi-
cates
. The display will then indicate
. Use the
or
buttons to
deactivate the optical sensor. The display will then indi-
cate
. Proceed in the reverse order
to reactivate it.
10 -
Once the pre-heating process has been completed,
the display will indicate the sensor and remote control
status as follows:
- If the remote control is activated, the display will indi-
cate:
.
- If the optical sensor is activated, the display will indi-
cate:
.
- If both functions aforementioned are activated, the
display will indicate :
.
- If both functions are deactivated, the display will indi-
cate:
.
