English
irLEDFLAT-5x12SIXb
- 5 RGBWA-UV LEDs compact projector with infrared remote control
Page 4
4 - Description
1
Power input/output socket
Allows you to connect the projector to an electrical outlet and
to link several projectors together via a Male/Female IEC cord.
Please make sure the voltage is in adequation with the product
indications.
Caution
: Do NOT go over 700W on the same power source.
2
Fuse
If need to replace the fuse, please make sure the new fuse has
exactly the same characteristics as the original one.
3
DMX input
3-pin female XLR plug hardwired as follows :
- Mass: 1
- Negative signal: 2
- Positive signal: 3
.
4
DMX output
3-pin male XLR plug hardwired as follows :
- Mass: 1
- Negative signal: 2
- Positive signal: 3
5
Display
This intuitive display allows you to configure your projector.
Please refer to the next paragraphs for more details about the
projector configuration.
6
MODE button
Allows you to access menus and select a function.
7
SETUP button
Allows you to configure the parameters of the functions chosen
with the MODE button.
8
UP button
Press UP to increase the adjustable values or browse the sub-
menus.
9
DOWN button
Press DOWN to decrease the adjustable values or browse the
sub-menus.
10
Infrared receiver input
This Jack 3.5 plug allows you to connect the infrared repeater
system.
This receiver can be used when the front sensor of the projector
is too far to receive the remote control commands.
5
6
8
7
9
3
4
10
1
2
