GOBOBEAM
- Animation effect with 8 x 3W LEDs and moving gobos projection
Page 4
English
4 - Internal menu
4.1 - Menu tree and description
Upon initialisation, the projector will calibrate the position of each motor.
Once completed, you can access the menu by pressing MENU or ENTER.
9
DMX output
3-pin female XLR plug hardwired as follows:
- Pin 1: Mass
- Pin 2: Negative signal
- Pin 3: Positive signal
10
DMX input
3-pin male XLR socket hardwired as mentioned above.
Allows to transmit the signal from another projector or DMX
console.
11
Display and menu buttons
Display
Allows you to intuitively configure your device. Please refer to
next paragraph for more details about the menu functions. The
backlight can be turned off via the Backlight function from the
menu.
MODE
Button
ALlows you to access the menu and select a function.
ENTER Button
Allows you to enter sub-menus and apply changes.
UP and DOWN buttons
Allows you to increase or decrease parameter values.
MENU
UP and DOWN
Action
ENTER
DMX address
DMX address selection.
Press Enter and use UP and DOWN to select values.
Saves
changes
DMX modes
1
channel: Show selection
Press Enter and select a
mode with UP and DOWN
Saves
changes
8
channels: Tilt1 / Dimmer / Strobe / Red / Green / Blue
/ Amber / Show selection
12
canaux : Tilt1 / Tilt 16 bits / Dimmer / Strobe /
Rouge / Vert / Bleu / Ambre / Vitesse du Tilt / Modes de
Dimmer / Sélection des shows / Vitesse des shows
Slave modes
Allows you to determine the behaviour of your projector in slave mode:
-
Master: Commands the Slave units
-
Slave 1: The device is in slave mode and mimics the Master unit.
-
Slave 2: The device is in slave mode and mimics the Master unit in reverse
order.
Saves
changes
Shows selection
-
Select shows from 0 to 4
Saves
changes
Dimmer control
Allows you to adjust the dimmer behaviour.
-
Fast: LEDs instantly power on/off.
-
Smoo: LEDs take a few second to power on/off in order to mimic halogen
projectors.
Saves
changes
Music-sensitive mode
Activates or deactivates the music-sensitive mode.
Press Enter and select On or Off with the UP and DOWN buttons.
Saves
changes
