Contemporary Research Corporation
4
ICC/ICW Smart TV Controller
Specifications
Models
ICC1-P
Philips TV, 1-Way RF
ICC1-R
RCA TV, 1-Way RF
ICC1-Z
Zenith TV, 1-Way RF
ICC2-P
Philips TV, 2-Way RF
ICC2-R
RCA TV, 2-Way RF
ICC2-Z
Zenith TV, 2-Way RF
ICW-P
Philips TV, iCW-Net
ICW-R
RCA TV, iCW-Net
ICW-Z
Zenith TV, iCW-Net
Philips:
SmartPlug compatible, PL, PA series (most) and PC series
Some PC series require Card01A, MonCard, SterCard, or ProKit1 Card for SmartPlug
Will not operate with Philips ScanCard TVs
RCA:
SmartPlug DSCI compatible, J series Lodging televisions PL series
8-pin
models
provide
12 VDC power to ICC/ICW units
Zenith:
MPI compatible, Concierge series, Presentation series, and Health View models
Physical
Size:
5.47" [139mm] wide x 6.35" [161mm] height x 1.13" [29mm] deep
Weight:
12 oz [341g]
Enclosure:
All aluminum with durable black powder coat paint
Mounting:
Mounts out of sight on rear of TV
Front Panel
Net LED:
Green LED for iC-Net bus, flashes once per second if receiving communication
TV/COM LED:
Yellow LED, flashes when IR data received, stays off when Smart link is not present
Error LED:
Red LED indicates a problem within the unit
Connections – ICC2, ICC1
RF Out:
F’, female, 75 ohm impedance, RF to TV. less than -1.5 dbmV loss
RF In/iCC-Net:
‘F’, female, 75 ohm impedance, RF from CATV system
iCC-Net:
Carried over the same RF coax connection as TV channels
Receive:
(ICC2, ICC1) Mid-band VHF, 74.7MHz, sent from ICC-HE Head-End Network Controller
-25 to +35 dBmV signal level
Transmit:
(ICC2 only) Sub-band, 5.6MHz sent to Head-End Network Controller
±80 KHz max carrier deviation
+49dBmV nominal
To TV:
RJ-11 female 6-pin Telco jack, accepts included Smart TV data cable
Power In:
2.1mm coaxial jack (inside center conductor positive), 100 mA maximum
9 to 16.5 VDC, 12 VDC typical (may be unregulated)
UL/CSA listed wall power supply included if needed for domestic shipments
Connections – ICW
iCW-Net
RJ-45 female 8 pin Telco jack
RS-485 type data requiring at least 2 twisted wire pairs with shield or fifth conductor
Recommended Wire: CAT3/CAT5 compatible unshielded, max 3300 feet [914m] from iC Head End
To TV:
RJ-11 female 6-pin Telco jack, accepts included Smart TV data cable
Power In:
2.1mm coaxial jack (inside center conductor positive), 100 mA maximum
9 to 16.5 VDC, 12 VDC typical (may be unregulated)
UL/CSA listed wall power supply included, if needed, for domestic shipments
