Contemporary Research
4
ICC1-IR
Specifications
Physical
Size:
5.5" [140mm] wide x 1.1" [28mm] height x 3.4" [86mm] deep
Weight:
8 oz [226g]
Enclosure:
All aluminum with durable black powder coat paint
Mounting:
Mounts rear of TV
Rear Panel
RF In
‘F’, female, 75 ohm impedance, RF from CATV system, iCC-Net control
RF Out:
‘F’, female, 75 ohm impedance, RF to TV, less than -1.5 dbmV loss
Net LED:
Green LED for iC-Net bus and DC power, flashes once per second if active
IR Out:
3.5mm jack for CC-IRE IR Emitter cable or compatible CC-IRS serial cable
Supports carrier frequencies up to 62 KHz
Shipped with CC-IRE cable, 10 foot with stick-on IR emitter
IR Out LED:
Red LED lights when sending IR commands
Power Sensor:
3.5mm jack for included CC-HSD scan sensor
Also acts as logic level input, switch to GND to signal power on
Power Sensor LED:
Red LED lights when sensor indicates power on
Power In:
2.1mm coaxial jack (inside center conductor positive), 75 Ma maximum
11.5 to 16.5 VDC, 12 VDC typical (may be unregulated)
North American version includes UL/CSA listed wall power supply
DIP Switches:
S1 and S2, located on bottom of unit, sets IR code operation and device number
iCC-Net
Operation:
1-way control, carried over the same RF coax connection as TV channels
Data Receive:
Mid-band VHF, 74.7MHz, sent from ICC-HE
-25 to +35 dBmV signal level
CC-HSD Scan Sensor
Range:
Senses presence of TV scanning, from 15-35 KHz, magnetic pick-up
Includes:
3.5mm plug, 4ft. cable, stick-on TV sensor
Includes
CC-HSD Scan Sensor
CC-IRE IR Emitter
RF Loop cable, 18”
12 VDC power supply, 500 mA
Mounting Velcro for unit and CC-HSD
