- 3 -
b. As soon as you have entered a 3-digit code that turns your TV off, press [MUTE].
1. If the TV turns back on, press [SEL / OK] to lock in the code. The power / mode buttons will blink 3-
times and go out.
Or
2. If the TV does not turn back on, enter a different 3-digit setup code until your TV turns back on.
Then press [SEL / OK] to lock in the code. The power / mode buttons will blink 3-times and go out.
4. To program your Video & Audio devices, refer to the VCR / DVD & Audio Setup Code lists and repeat steps
2 and 3 above.
Point and Press
®
Programming
This method allows you to program the remote control without using codes. Instead, the remote control
automatically finds the correct command that you select in a variety of codes until you find the code that operates
your device. You then lock in the correct code as described below.
The following instructions describe how to program your remote control using the [CH +] or [CH -] buttons ("Power"
function during programming). You may also program your remote control using other buttons / functions as
described in Section 11. When using this method, there are several important points to remember:
•
The order in which you program your electronic devices is not important.
•
There may be several codes that turn your electronic devices on / off (or perform other functions). Once you
lock-in a code, be sure to check the available functions for that device (i.e. TV - VOL +/-, MUTE, TV Input
(Input), VCR or DVD - PLAY, STOP, REW…) to see if they are operating.
•
While the remote is searching for the correct setup code(s) for your electronic devices, it is possible that
other (previously programmed) devices may turn on / off (or perform other functions). If this occurs,
continue pressing the [CH +] or [CH -] buttons (or the buttons described in Section 11) until you find the
correct code for the device you are programming.
It may take several minutes for the remote to find the correct code that turns your device off (or performs
another selected function). During this time, the power / mode buttons will illuminate in fast-rotation (i.e. S-A
Æ
TV
Æ
VIDEO
Æ
AUDIO
Æ
MOT…).
Programming your electronic devices using the [Ch +] or [Ch -] buttons (“Power” function during
programming)...
1. Turn on all the electronic devices (TV, VCR or DVD, Audio) you want to program the remote to operate.
2. Press [SEL / OK], then [MUTE] together until the power / mode buttons illuminate in slow-rotation (i.e. S-A
Æ
TV
Æ
VIDEO
Æ
AUDIO
Æ
MOT…).
3. Press and hold the [CH +] button until one device turns off. While you are pressing the [CH +] button, the
power / mode buttons will illuminate in fast-rotation. As soon as one device turns off, release the [CH +]
button.
4. Press [MUTE]. If the device that turned off...
a. Turns back on, press [SEL / OK] to lock in this code. The power / mode buttons will blink 3-times and go
out.
Or
