Contec IPC SERIES, User Manual

Page: 11 / 47

2. Specifications
6
FPD-M75VT-DC1, FPD-L75ST-DC1, FPD-H75XT-DC1
Table 2.2. Power Supply Specifications
Item
Specification
FPD-M75VT-DC1 FPD-L75ST-DC1 FPD-H75XT-DC1
Power supply input part
Power supply connector
4-pin connector for +12 - 24VDC power supply
AC adapter jack
Corresponding to +12 (±5%) VDC output AC adapter
Input power supply voltage
+12V-24VDC±5
％
Consumption current
1.4A(Max.) 1.4A (Max.) 1.6A (Max.)
Consumption current
(power save mode)
0.4A (Max.)
General Specifications
Table 2.3. General Specifications
Item
Specification
FPD-M75VT-DC1 FPD-L75ST-DC1 FPD-H75XT-DC1
Environment
Operating temperature *1
0 - 50ºC
0 - 40ºC (when using an AC adapter)
Storage temperature
-10 - 60 ºC
Operating humidity *2 10 - 90
％
RH (No condensation)
10 - 85
％
RH (No condensation) (when using an AC adapter)
Floating dust particles Not to be excessive
Corrosive gas None
Noise
resistance
Line noise AC line: 2 kV *3, Signal line: 1 kV
(IEC1000-4-4Level3
、
EN61000-4-4Level3)
Electrostatic
withstanding
voltages
Contact : 4 kV (IEC1000-4-2Level2, EN61000-4-2Level2)
Airborne : 8 kV (IEC1000-4-2Level3, EN61000-4-2Level3)
Vibration resistance
10 - 57 Hz/Single-side amplitude or 0.075 mm
57 - 150 Hz/1.0 G in the X/Y/Z directions for 40 minutes each
(Conforming to JIS C0040 and IEC68-2-6)
Shock resistance 10 G in the X/Y/Z directions for 11 ms; Half-sine wave
(Conforming to JIS C0041 and IEC68-2-27)
Structure
Physical dimension (mm) 292(W) x 43(D) x 234(H) 318(W) x 43(D) x
252(H)
380(W) x 44(D) x
298(H)
Panel cut dimensions (mm) 216(W) x 164(H)
(Requires eight
surrounding M3 stud
holes or round
φ
4 holes)
252(W) x 190(H)
(Requires eight
surrounding M3 stud
holes or round
φ
4
holes)
309(W) x 233(H)
(Requires eight
surrounding M3 stud
holes or round
φ
4
holes)
Weight
2.1kg 2.4kg 3.6kg
Waterproofing and
dust-proofing Front part conforming to IP65 (Use the packing supplied.)
*1 In the installed angle which is recommended. For more details on the Operating temperature, refer to the
Installation Requirements.
*2 Wet-bulb temperature 38 ºC or lower
*3 When using the optional AC adapter IPC-ACAP12-02.