2. Setup
GP-IB(PCI)F, GP-IB(PCI)FL, GP-IB(LPCI)F, GP-IB(LPCI)FL
17
Setting the Board ID
If you install two or more boards on one personal computer, assign a different ID value to each of the
boards to distinguish them.
T he board IDs can be set from 0 - Fh to identify up to sixteen boards.
If only one board is used, the original factory setting (Board ID = 0) should be used.
Setting Procedure
To set the board ID, use the rotary switch on the board. T urn the SW1 knob to set the board ID as shown
below.
BOARD ID
SW1
01
23
45
67 9ABC
D
EF
8
(Board ID = 0)
Factory setting:
Figure 2.3. Board ID Se ttings (SW1)
Plugging the Board
(1) Before plugging the board, shut down the system, unplug the power code of your PC.
(2) Remove the cover from the PC so that the board can be mounted.
(3) Plug the board into an expansion slot.
(4) Fasten the board bracket to the PC’s chassis with the removed screw.
(5) Put the cover back into place.
(T he photograph shows the card installed in a PCI slot.)
