Contec DIO-96D2-LPCI, User Manual, Page: 23 / 65

2. Setup
16
DIO-96D2-LPCI
Step 2 Setting the Hardware
This section describes how to set the board and plug it on your PC.
The board has some switches and jumper to be preset.
Check the on-board switches and jumpers before plugging the board into an expansion slot.
The board can be set up even with the factory defaults untouched. You can change board settings later.
Replacing the Bracket
This product is shipped with a Low Profile size bracket mounted. To plug the product into a standard
size slot, replace the bracket with the bundled standard size bracket. The replacing method is as follows :
Screw
Use a flathead screwdriver or hexagonal spanner to undo and tighten the screws.
Standard size bracket
- Remove the screws and replace it
with the Standard size bracket.
Low Profile size bracket
Figure 2.1. Replacing the Bracket