Contec DIO-1616RY-PE, User Manual

Page: 24 / 62

2. Setup
Setting the Board ID
If you install two or more boards on one personal computer, assign a different ID value to each of the
boards to distinguish them.
The board IDs can be set from 0 - Fh to identify up to sixteen boards.
If only one board is used, the original factory setting (Board ID = 0) should be used.
Setting Procedure
To set the board ID, use the rotary switch on the board. Turn the SW1 knob to set the board ID as shown
below.
BOARD ID
(Board ID = 0)
Factory setting :
SW1
01
23
4
5
67
9A
B
C
D
EF
8
Figure 2.2. Board ID Settings (SW1)
Selecting the Input Voltage Range
The rated input voltage range of the board is 12 - 24 VDC or 24 - 48 VDC. Set the jumper for each input
channel to the desired voltage range depending on the corresponding input signal voltage.
Setting method
Set the on-board jumpers JP1 - JP16 to 12 - 24 or 24 - 48 VDC.
For the input voltage
between 12 - 24 VDC
Connect jumper pins 1 and 2 together.
(factory setting)
Connect jumper pins 2 and 3 together.
3
2
1
JP1 - 16
JP1 - 16
3
2
1
For the input voltage
between 24 - 48 VDC
Figure 2.3. Selecting the Input Voltage Range (JP1 - JP16)
Jumpers correspond to input signals as follows:
Input
signal
JP
Input
signal
JP
Input
signal
JP
Input
signal
JP
I-17 JP1 I-13 JP5 I-07 JP9 I-03 JP13
I-16 JP2 I-12 JP6 I-06 JP10 I-02 JP14
I-15 JP3 I-11 JP7 I-05 JP11 I-01 JP15
I-14 JP4 I-10 JP8 I-04 JP12 I-00 JP16
DIO-1616RY-PE
17