1. Before Using the Product
4
DIO-6464L-PE, DI-128L-PE, DO-128L-PE
Cable & Connector (Option)
Shielded Cable With Two 100pin Connector
:
PCB100PS-0.5
(0.5m)
:
PCB100PS-1.5
(1.5m)
:
PCB100PS-3
(3m)
:
PCB100PS-5
(5m)
Connection Conversion Shield Cable (100P
→
96P)
:
PCB100/96PS-1.5
(1.5m)
:
PCB100/96PS-3
(3m)
:
PCB100/96PS-5
(5m)
Flat Cable with One 100-Pin Connector
:
PCA100P-1.5
(1.5m)
:
PCA100P-3
(3m)
:
PCA100P-5
(5m)
Connection Conversion Shield Cable (100P
→37
P D-SUB x 2)
:
PCB100WS-1.5
(1.5m)
:
PCB100WS-3
(3m)
:
PCB100WS-5
(5m)
*
If using both the CNA and CNB connectors, two cable sets are required.
Accessories (Option)
Screw Terminal Unit (M3 x 100P)
: EPD-100A *1*4*6
Screw Terminal Unit (M3 x 96P)
: EPD-96A *2*4*6
Screw Terminal Unit (M3.5 x 96P)
: EPD-96 *2*4
Terminal Unit for Cables (M2.5 x 96P)
: DTP-64(PC) *2*4
Connector Conversion Board (96-Pin
→
37-Pin x 2)
: CCB-96 *2*4
Signal Monitor / Output Accessory for Digital I/O (64P)
: CM-64(PC)E *2*4
Screw Terminal Unit (M3 x 37P)
: EPD-37A *3*5*6
Screw Terminal Unit (M3.5 x 37P)
: EPD-37 *3*5
General Purpose Terminal (M3 x 37P)
: DTP-3A *3*5
Screw Terminal (M2.6 x 37P)
: DTP-4A *3*5
*1 PCB100PS optional cable is required separately.
*2 PCB100/96PS optional cable is required separately.
*3 PCB100WS optional cable is required separately.
*4 If using both the CNA and CNB connectors, two each of the terminal block and cable sets are
required.
*5 If using both the CNA and CNB connectors, two cable sets are required.
You will also require sufficient terminal blocks for the number of I/O points you are using.
*6 “Spring-up” type terminal is used to prevent terminal screws from falling off.
*
Check the CONTEC’s Web site for more information on these options.