Contec CONPROSYS CPS-PCS341MB-DS1-1201, Reference Manual

Page: 41 / 65

—
Installation
—
CPS-PCS341MB-DS1-1201 Reference Manual (Hardware)
— 41 —
2. Connecting to an External Device
Use the supplied connector plug to connect the product to an external device.
The following example describes how to make the connecting cable with a supplied connector.
Example of making the connecting cable with a 3-pin connector
1
Strip off approximately 7mm (plus or minus 0.5mm) of the covered part of a cable and insert it
to the opening.
2
After the insertion, secure the stripped part by turning screws with a slotted driver to prevent it
from disconnecting.
CAUTION

Removing the connector plug by grasping the cable can break the wire. Always grasp the
connector to remove it.

Tightening torque of the supplied connector is 0.19N·m.

Strip off approximately 7mm (plus or minus 0.5mm) of the covered part of a cable to connect
with the connector.
Connection cable
The supplied
connector
Power Supply
or
External Device