58
BX-S959SD Series
User’s Manual
39
.4
0
33
.0
0
Table 5.5. DVI–analog RGB conversion adapter
Connector type
DVI-I 29 pin
C5
C4
C2
C3
C1 6
16
24
8
1
11
5 15
17
1
10
15.00
6.20
30.00 5.80
[mm]
Analog RGB signals
Pin No.
Signal name
Pin No.
Signal name
1
RED
9
+5V
2
GREEN
10
GND
3
BLUE
11
N.C.
4
N.C.
12
DDC DATA
5
GND
13
HSYNC
6
GND
14
VSYNC
7
GND
15
DDC CLK
8
GND
-
If the OS is booted without connecting the display cable to the DVI interface, and then the display is
connected after the OS boots, the display may not be shown properly.
-
When the analog display is used, Windows MS-DOS may not be properly displayed in full-screen mode.
This is because the frequency and resolution of Windows and MS-DOS (full-screen display) are the same
due to the screen settings while the display parameters are different.
For display, as only one parameter can be stored for one frequency or resolution, only either of Windows
or MS-DOS screen can be displayed properly.
In this case, change the resolution or display frequency of Windows so that it is not the same as for the
MS-DOS display.
-
When using a digital display, an analog display may be detected even though no analog display is
connected.
-
This will not affect how the digital display appears. However, change the multi-display settings as
necessary.
-
To change the settings from digital output to analog output, change the settings from the standard
Windows properties screen.
