10
N° OF
BLINKS / BEEPS
FAULT DESCRIPTION
POSSIBLE SOLUTION
1
Printer ribbon not present
Check condition of the ribbon and that it
threaded correctly. Switch TTPCard OFF and
then ON again after a few seconds.
3
Print head not lowered
Switch TTPCard OFF and then ON again after
a few seconds. Press the BLUE button (4) to
move the carriage and ensure it is operating
correctly.
4
Print head not raised
Switch TTPCard OFF and then ON again after
a few seconds. Press the BLUE button (4) to
move the carriage and ensure it is operating
correctly.
5
Carriage not in correct
starting position or out of
position
Switch TTPCard OFF and then ON again after
a few seconds. Press the BLUE button (4) to
move the carriage and ensure it is operating
correctly. Remove any obstacles preventing full
movement of the carriage.
6
Carriage not moving correctly
or in wrong position
Switch TTPCard OFF and then ON again after
a few seconds. Press the BLUE button (4) to
move the carriage and ensure it is operating
correctly.
8...11
System software or printer
driver malfunction
Check the printer driver and system default
settings are correct. Switch TTPCard OFF and
then ON again after a few seconds
12.....
TTPCARD electronic
controller malfunction
Switch TTPCard OFF and then ON again after
a few seconds If the problem persists please
contact CONTA-CLIP,
15
RFID inlay / plate error
Check if the inlay type is correct.
Deactivate plate / inlay control under the printer
settings in CONTASign Pro, or contact
CONTA-CLIP
Green button (4):
authorised user only TEST mode, accessed by pressing green button (4) for more
than 6 seconds during the initial start-up cycle, is indicated by the yellow and orange LEDs blinking
simultaneously. Inadvertent access may be cancelled by switching the TTPCard OFF and then ON
again after a few seconds.
