_ Always lead the mains cable away backwards from
the device.
_ Store the device where it is inaccessible to children.
_ When carrying out work, always hold the device with
both hands and ensure that you have a stable
standing position.
ELECTRICAL SAFETY
Always check that the power
supply corresponds to the
voltage on the rating plate.
DESCRIPTION
Your hammer drill has been designed for
drilling in concrete, stone, wood and steel and
for light chipping and chiselling applications.
1 On/off switch
2 Switch hammer function
3 Switch chisel function
4 Chuck
5 Collar
6 Side handle
7 Cover lubrication point
8 Variable speed (Min/1~6/Max)
BEFORE USING THE TOOL FOR THE FIRST TIME
_ Examine the place where the device is to be used
for hidden electrical cables, gas and water pipes using
a pipe finding device.
_ Before connecting to !he mains, ensure care that the
mains voltage corresponds to the details on the rating
plate.
MOUNTING AND REMOVING A BIT OR CHISEL
This tool uses drill bits and chisels with a special tool
holder system for quick and easy mounting.
Apply a small amount of grease on the bit
or chisel shaft.
Pull the collar (5) backward and insert the
shaft of the bit or chisel into the drill chuck (4). Turn
the bit or chisel until the shaft is locked in the drill
chuck.
Release the collar (5).
In order to remove the bit or chisel, pull the collar (5)
backward and remove the bit or chisel from the drill
chuck.
Before mounting or removing
a bit or chisel, first remove
the mains plug from the
socket.
Accessories can be hot after
use. Don’t touch the tip of
accessory by hand!
Please always use protective
floves to remove accessory.
MOUNTING THE SIDE GRIP
For reasons of safety, only use the hammer drill with
handle attachment.
You will be able to obtain a safe body position when
working by rotating the handle attachment.
Loosen and turn the handle attachment in an ant-
clockwise direction. Then tighten the handle
attachment.
Loosen the side grip (6).
Slide the holder of the side grip over the
drill chuck on the machine.
Turn the side grip in the required position
and tighten it firmly.
DEPTH STOP
Loosen the lock knob for depth stop and place the
straight part of the depth stop in the hole.
Adjust the depth stop and retighten the handle
attachment.
DUST COLLECTION DEVICE
Before carrying out hammer-drilling work vertically
overhead pull dust collecting device over
the drill bit.
SELECTING THE OPERATING MODE
The machine must be set to the required
function (drilling, hammer drilling or
chiseling) before use.
For drilling without hammering (in soft
stone, wood or steel) you turn the hammer
function switch (2) to position
and the
chisel function switch (3) to position
.
For hammer drilling (in concrete or hard
stone) you turn the hammer function
switch (2) to position
and the chisel
function switch (3) to position
.
For chiseling you turn the hammer functiop
Switch (2) to position
and the chisel
function switch (3) to position .
In this position the drill chuck does not rotate.
Only set the hammer
functions (2) and (3) when the
machine is switched off.