7
–
Catch the fin to remove the final filter.
Black
surface
Open
–
materials which are difficult to make damp such as: gypsum, cement, stone dust, flour, etc.
– too big and too sharp objects, which can be blocked inside the tube, hose or air ducts.
– In order to do use blowing, please set the air recirculation module knob in blowing position.
You can use this function for different purposes, especially for:
– blowing leafs out of balcony or patios,
– drying with warm air the inner walls of tubes and hose and other damp objects.
AFTER OPERATION WITH WATER FILTER
After operation with
“water filter unit”
it is necessary to perform proper activities in order to clean inner
elements of the tank and prepare it for storage.
–
Switch the vacuum cleaner off and unplug it.
– Remove the hose ending.
–
Black surface − remove the water filter unit from the vacuum cleaner.
– Remove the inner module from the tank.
–
Press the flexible hook of the separator frame with your finger,
disassemble the water separator and remove initial filter.
–
If it is necessary, remove the node, flush it and assemble again, taking
care for proper assembling.
–
Water filter unit - clean tank, separator and initial filter under running
water. Clean the parts thoroughly.
– Dry after cleaning. You can do it in two different ways:
1. Disassemble the parts and leave them until they get dry. Assemble
after drying and insert complete tank into the vacuum cleaner.
2. Assemble complete vacuum cleaner after cleaning (without water)
and switch it on for about 5 min. (Drying with airflow).
ATTENTION!!! Leaving not completely dried parts inside the assembled vacuum cleaner can
cause unpleasant smell.
In case of incidental getting the accessories wet (tubes, hose or nozzles inside) you should stop the
vacuuming switch the vacuum cleaner off and dry the wet parts.
In order to do it, please set the air recirculation module knob in blowing position and switch the vacuum
cleaner on for about 2 min. The activity is performed to dry the hose, pipes and other accessories in
contact with water. It prevents bacteria development during storage.
FILTERS CONTROL
The vacuum cleaner is equipped with the following filters:
1. Separator and initial filter
Activities connected with cleaning are described in part concerning after
operation activities.
– Washing of these parts shall be held after each vacuuming.
– Assemble the parts In reverse sequence to disassembling.
–
Be careful during assembling initial filter, so that black surface of the filter
was outside (up).
2. Final filter
Final filter removing
– Remove the back tank from the housing and turn the vacuum cleaner so that
it was supported with upper, inclined surface and the handle on the floor.
– Move the cursor into such position, that the open mark was visible.
–
Open the filter lid according to the figure beside.
Black
surface
819-141C_v01
