Consort Equipment Products Limited
Thornton Industrial Estate, Milford Haven, Pembrokeshire, SA73 2RT
Tel: 01646 692172 Fax: 01646 695195
Email: [email protected] Web: www.consortepl.com
Operation hours: Mon to Thu 8.30am to 4.30pm | Fri 8.30am to 3.30pm
48000035 Iss 11
F
ROST
F
IGHTER
S
ETTING
Your appliance can be used in various situ-
ations to protect against frost.
Examples are; in the attic, protecting water
tanks and pipes.
To set the unit to function in these environ-
ments, turn the thermostat knob anti-
clockwise to the ‘frost fight’ position, as
shown in figure 2..
The thermostat is now set at approximately
5
0
C. This means that when the air tempera-
ture around the unit drops below approxi-
mately 5
0
C the unit will switch itself on. It
will continue to operate until the air tem-
perature surrounding the unit rises above
5
0
C and then will switch itself off, coming
back on again when the temperature starts
to drop.
T
HERMAL
O
PERATED
C
UT
-
OUT
The appliance is fitted with a thermally op-
erated cut-out (TOC). This is a safety de-
vice, which switches the heater off if, for
any reason, the appliance overheats. The
TOC can only be re-set after the appliance
has cooled down. In order to re-set the
TOC, proceed as follows:
Switch off appliance and leave for
approximately 5 minutes.
Switch appliance back on and the
TOC will re-set.
Ensure that the appliance is function-
ing correctly. If the ES Control oper-
ates again, the appliance should be
checked by a competent Electrician.
Controls
Model UHA05 has a heat rating of 0.45 kW.
Model UHA10S, which is fan assisted, has a
heat output of 1.0 kW and incorporates a
switch which controls the element. With the
switch in the position shown in Diagram D,
both element and fan are engaged.
With the switch in the position shown in Dia-
gram E the fan only will run.
Both these switch settings are subject to
thermostat control.
T
HERMOSTAT
The appliance is fitted with a thermostat. To
set the thermostat to the require tempera-
ture turn the control knob fully clockwise, to
the position shown in figure 1 . When desired
room temperature is reached, turn the knob
slowly anti-clockwise and when the thermo-
stat clicks off leave the control at this set-
ting. hereafter the appliance will control the
heat output automatically. A ‘Frost Fighter’
position is marked on the unit. This is the
lowest setting on the thermostat and repre-
sents approximately 5
0
C.
C
USTOMER
H
ELPLINE
Should you need any advice on the use of your new Consort product, please contact
our Helpline:
4
Figure 1
Figure 2
