13984134 Iss 1
3
Specification.
This heater produces a totally dry heat, no
condensation, no gas, no fumes and no
smell. It reaches maximum heat output with-
in seconds of being turned on and has a
highly polished aluminium reflector for maxi-
mum heat efficiency. It adjusts horizontally
through 90° while mounted. And is Ideal for
industrial or domestic applications, IP55 rat-
ed.
Mounting Instructions.
WALL MOUNTING
IMPORTANT!
The following points should be
noted:
The heater should always have a
minimum clearance of 500mm from a
ceiling and at least 1000mm from any ob-
ject.
IMPORTANT!
Ensure that the mounting sur-
face is capable of supporting the weight of
the heater.
IMPORTANT!
The heater should be mounted
horizontally where possible or at a maximum
angle of 35 degrees from the horizontal.
IMPORTANT!
The mounting bracket must be
sufficiently earthed.
•
Remove the wall mounting bracket from
the heater by removing the wo bolts from
either end of the bracket.
•
Before drilling ensure that there are no wires
or water pipes in the area where the heater
is to be placed.
•
Use the bracket as a template. Fix the met-
al bracket to the wall by using a minimum
of 3 holes and appropriate fixings (not sup-
plied).
•
Refit the heater back onto the bracket,
•
Adjust the angle of heater to direct heat
where required, between 45°and 90° (see
fig.1).
•
Now tighten up the two bolts tightly
PARASOL MOUNTING.
IMPORTANT!
Only the QZWP30N is capable of
parasol mounting.
the supplied bracket for clamping to a para-
sol arm. You must ensure the canvas / mate-
rial of the parasol is at least 500mm away
from the back of the heater and can not
come into contact with high winds.
Electrical connections
WARNING:
Ensure that the electrical supply is
isolated and made safe before making any
electrical connections.
WARNING:
The Quartz heater must be con-
nected to a known good earth. The terminal
block earth terminal is clearly marked with
the standard earth symbol.
NOTE:
If Quartz heaters are NOT being used
in conjunction with a Quartz driver unit then,
because of the high surge currents associat-
ed with tungsten loads, it is recommended
that Type ‘B’ circuit breakers are used with a
current rating of 2 x the heater load.
Connection to a Switched Fused Spur / Isola-
tor.
•
Connect the GREEN/YELLOW earth wire to
the earth connection.
•
Connect the BROWN live wire to the live
connection.
•
Connect the BLUE neutral wire to the neutral
connection’.
•
After wiring, check that there are no bare
wires, that all wires have been correctly
connected, that the cable outer insulation
extends beyond the cable restraints and
that the restraint is tight.
Model
QZWP45N QZWP30N
QZWP15N
Power
4500w
3000w
1500w
Input Supply 240/415v
50Hz
240v 50Hz
240v 50Hz
Dimensions 1440x125x
125mm
960x125x125
mm
480x125x125
mm