Locking tab
Locking screw
15. Optional PLK1 Locking Device
- Locking screw
- Locking tab
The PLK1 locking device can be used to mechanically
lock the controls to prevent tampering with settings. As it
is not supplied with the heater, kindly contact our Sales
team if required.
16. Mounting
To wall mount, the wall bracket supplied must be used.
Please refer to illustrations in Fig.1.
Remove wall bracket from the heater. Fix wall bracket to
wall using screw holes provided. Present heater to
bracket. Locate heater onto bottom lugs via 2 sets of
relevant slots in rear panel. Hinge heater upwards and
locate the top tabs into the slots in the back of the
heater and ‘click’ into position. The heater MUST not be
powered until it is in this position.
To remove the heater from the wall first disconnect the
power then press down on the two top tabs to release
the heater. Hinge the heater forward on the bottom
lugs. The heater can be now lifted off the bottom lugs to
remove it from the wall. The heater must not be located
immediately below a fixed socket outlet.
66001079 Iss 03
