Controls
When the appliance is connected to the
mains supply and the wall socket is
switched ‘ON’ the mains LED indicator will
light, showing that the power is available
to the unit.
4
66000960 Iss 02
Operation
This heater can only be used in
conjunction with a CRXSL wireless
programmable controller. Each CRXSL
can control any number of heaters in the
same room.
CRXSL wireless controller
Please refer to the CRXSL installation and
control guide for full operational details.
C
USTOMER
H
ELPLINE
Should you need any advice on the use of your new Consort product please contact our Helpline:
Consort Equipment Products Limited
Thornton Industrial Estate, Milford Haven, Pembrokeshire, SA73 2RT
Tel: 01646 692172 Fax: 01646 695195
Email: [email protected] Web: www.consortepl.com
Operation hours: Mon to Thu 8.30am to 4.30pm | Fri 8.30am to 3.30pm
BS EN ISO 9001 Registered Company No FM12671
Mounting
To wall mount, the wall bracket supplied must
be used.
Remove the wall bracket from the heater, with
the chains attached, by removing the 2
securing screws from the top of the rear panel.
Fix the wall bracket to the wall using 4 screws.
Fig 1: Present the heater to the bracket
Fig 2: Locate the heater onto the bottom lugs
via the 2 slots in rear panel. Hinge the heater
upwards and reattach the chain assembly, then
move the heater to the upright position. The link
plates should slide under the slotted bracket lip.
Fig 3: Tighten both retaining screws.
The heater must not be located immediately
below a fixed socket outlet.
