Conservator GRM183QB, Installation & Operation Manual

Page: 16 / 59

15
1 cold 2 colder
3 colder
4 colder
5 coldest
Temperature control operation
1. Initial setting of fresh compartment control panel is 3, for the fr ee ze r compartment, the initial
setting is Mid position.
2. If the ambient temperature i
n the fresh food compartment is too cold, press the SET button to go
to a lower number setting (1 or 2) , the fr ee ze r compartment control knob sh ou l d be placed in the
COLDER position.
3. If the ambient temperature i
s too warm in the fresh food compartment press the SET button to a
higher number ( 4 or 5 )
position,
the fr ee ze r
compartment control knob sh
ould
be placed in Mid~
COLDER position.
This could require many adjustments to achieve your preferred setting.
Tips: When the frozen compartment control knob is placed in
COLD position, the fresh compartment will be more rapid ly cooled,
but if left in the COLD position for a long time, the temperature inside
fresh compartment may be reduced to below freezing.
(default)
• The first time you turn the refrigerator on, the control panel LEDs turn on for 3 seconds, the display will
show the current setting (default = 3). Your refrigerator will then run continuously for several hours until it
reaches the preset temperature. After your refrigerator is fully cooled, you can adjust the temperature up or
down to your personal preference.
• To temporarily suspend cooling in the refrigerator and freezer, press and hold the SET button for 3
seconds. The STANDBY LED turns on and cooling is turned off. Press the SET button again to cancel
standby mode and resume cooling.
1 SET button: Press to change the refrigerator setting from 1 (cold) to 5 (coldest).
2 LED indicators Light to show the current refrigerator setting.
3 STANDBY LED Lights to indicate when the refrigerator is in standby mode
(refrigerator and freezer are turned off ).
• If the refrigerator is unplugged or loses power, you must wait three to five minutes before restarting it. If you
attempt to restart before this time delay, the refrigerator will not start.
• Large amounts of food will lower the cooling efficiency of the refrigerator.
• If you choose to change the thermostat setting, adjust it by one increment at a time. Allow 24 hours for the
temperature to stabilize between adjustments.