Use in accordance with manufacturer’s instructions
The product is intended to be plugged into a cigarette lighter socket in a vehicle (vehicle voltage 12 -
24 V/DC), and is used to recharge a mobile telephone or alternatively, to supply the power
(5 V/DC, 1 A) to devices with USB plug.
Any other use than that described above may damage the product. Moreover, this may give rise
to hazards such as short-circuiting,
fi
re, etc.
This product complies with the applicable National and European requirements. All names of
companies and products are the trademarks of the respective owner. All rights reserved.
Package Contents
• Charger cable with integrated electronics
• 3 adaptor plugs
• Operating Instructions
Safety Instructions
The warranty will be void in the event of damage caused by failure to observe
these safety instructions! We do not assume any liability for any consequen-
tial damage!
Nor do we assume any liability for material and personal damage caused by
improper use or non-compliance with the safety instructions! In such cases
the warranty will be null and void.
• The unauthorised conversion and/or modi
fi
cation of the product is not permitted
because of safety and approval reasons (CE).
• The product is not a toy and should be kept out of the reach of children.
• The product must not get damp or wet.
• Keep the vehicle’s foot well and all operating elements free from connection cables
so as not to obstruct control of the vehicle.
• Do not operate the product while you are driving (e.g. plugging/unplugging the
mobile phone or connecting/disconnecting the USB device). Accident risk!
• Do not leave packaging material carelessly lying around since it could become a
dangerous plaything for children.
• Handle the product with care, it can be damaged by impacts, blows, or accidental
drops, even from a low height.
Getting Started
☞
Please note that, depending on the vehicle, the ignition has to be turned on before
the operating voltage is available at the vehicle’s cigarette lighter socket.
Plug the cigarette lighter plug on the charger cable into a suitable cigarette lighter socket in the
vehicle (vehicle voltage 12 - 24 V/DC).
When there is an operating voltage available, a blue LED lights up on the top of the cigarette
lighter plug.
Before plugging or unplugging the charger cable’s cigarette lighter plug into/out of
the vehicle’s cigarette lighter socket, disconnect all devices connected to the charg-
ing output or the USB socket.
Plugging/unplugging can cause voltage spikes, which might damage the connected
mobile phone or USB device.
a) Charging function for mobile phone
The charging output (jack on the cable end) provides a voltage of 5 V/DC and a maximum
output current of 1 A.
Only connect your mobile phone for charging, if it has an input voltage of 5 V/DC.
Connect the jack on the cable end to the adaptor suitable for your mobile phone and then con-
nect to the mobile phone.
Your mobile phone should now start to charge.
After a completed the charging process, disconnect the mobile phone from the charger cable,
unplug the charger cables’ cigarette lighter plug from the vehicle’s cigarette lighter socket.
b) Power Supply/Charging function for USB Devices
Slide the cover on the top of the cigarette lighter plug to the side,
see illustration on the right. Underneath, there is a USB socket,
type A ,which can be used for powering or charging a USB device.
The USB socket supplies an output voltage of 5 V/DC and a maxi-
mum current of 1 A.
After the charging is completed (or, if you no longer need the power
supply for the USB device), remove the USB plug from the cigarette
lighter plug’s USB socket.
Disconnect the charger cable’s cigarette lighter plug from the vehi-
cle’s cigarette lighter socket.
Tips and Notes
• If the operating voltage for your vehicle’s cigarette lighter socket is not deactivated when the
ignition key is removed, disconnect the charger cable from the vehicle. To do this, unplug
the cigarette lighter plug from the cigarette lighter socket to avoid unnecessary loads on the
vehicle’s battery.
• The charging electronics are integrated in the mobile phone or USB device. For the charging
process, please consult the operating instructions for the mobile phone or USB device.
• The charging output for the enclosed adaptors and the USB socket can be used simultane-
ously. An output voltage of 5 V/DC and an output current of 1 A are available.
Disposal
Dispose of the unserviceable product according to the relevant statutory regulations!
Technical Data
Operating voltage .........................12 - 24 V/DC
Output via round plug ...................5 V/DC, 1A
Output via USB socket .................5 V/DC, 1 A
Cable length .................................approx. 1 m
Dimensions ...................................106 x 38 x 23 mm
Weight ..........................................50 g
These operating instructions are a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1,
D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, micro
fi
lming,
or the capture in electronic data processing systems require the prior written approval by the editor.
Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in
technology and equipment reserved.
© Copyright 2011 by Conrad Electronic SE.
O P E R A T I N G I N S T R U C T I O N S www.conrad.com
Vehicle charger cable 4 in 1
Item no. 85 79 03
Version 07/11