36
• FS20
The corresponding FS20 addresses must be installed / programmed for the FS20 switching
actuator to be used to circulating pump and for the FS20 remote control to be used for
additional manual switching.
The procedure is as follows:
• After the selection of the menu item "Install remote control" (= "Handsender anlernen") press
one of the buttons of the desired button pair on the remote control.
• If the device has detected the code the display shows detection. If required, the set
programming can be replaced with another button on the remote control or another remote
control channel.
• It is also possible to delete the hand-held sensor from the control memory.
This also requires you to enter the "Install remote control" (= "Handsender anlernen") menu
item, however you then need to press one of the buttons of the desired button pair for longer
than 0.4 seconds. The display once again shows confirmation.
• The menu items "Set house code" (= "Hauscode setzen") and "Set address" (= "Adresse
setzen") are used to enter the house code and address of the switching actuator which the
"FS20 ZPS" is to control. At the least, the address should differ from that of the remote control
in order to avoid any undesired direct control of the actuator by the remote control.
The attachment provides an explanation of the FS20 address system.
• In order to programme the switching actuator to the previously set house code, the actuator
must be placed in programming mode as per the corresponding operating instructions and
the menu item "Test switching actuator" (= "Schaltaktor testen") is to be selected.
Now press the "OK/Menü" button – an FS20 command is sent and the switching actuator
should be programmed.
Further pressing of the "OK/Menü" button allows you to alternatively turn the switching
actuator on and off.
• As the switching actuator is now programmed to the controller, you can also test whether the
programmed remote control activates the switching actuator via the pump control. This
requires that the control to be placed in basic display setting and a button on the remote
control be pressed. The command sent by the "FS20 ZPS" switches the switching actuator
on for approx. 10 minutes.