27
d) Remote control
The remote control is operated with 2 x 1.5 V batteries type R03/LR03/AAA (not included).
•.
Open the battery compartment (37) on the rear of the remote control. Insert the batteries according to the correct
polarity (+/-).
•.
Use only batteries of the same or similar type.
•.
Remove all batteries if the device is not used for a longer period of time in order to prevent damages.
•.
Then close the battery compartment. Ensure that the lid is correctly fastened.
•.
Comply with the safety information regarding the handling of batteries/rechargeable batteries (see section
“b) Batteries/Rechargeable batteries”).
•.
Always point the IR sender (33) toward the IR receiver (32) on the operating panel (2) when using the remote
control.
•.
Ensure that there are no obstructions located between the remote control and the device, e.g. furniture, which
might block transmission of the signal.
8. Operation
Settings can be adjusted directly on the operating panel (2) of the device or the enclosed remote control.
Always place the device on a level, sturdy, and dry surface. Ensure a sturdy position, so that the device
cannot tip over or fall down.
When you connect to the power plug (7) to the power outlet, a signal tone sounds, the indicator light
POWER
(24) and the display (19) will light up. The device is now in standby mode
a) Switching on and off
•.
Push the key (25, 36) to switch the device on or off.
•.
The device is pre-set. When you switch the device on, the display (19) will show the temperature 22 °C, the
indicator lights
COOL
(21) and
LOW
(17) will light up. Low fan speed is pre-set. When the compressor switches
on, the indicator light
COMP
(15) will light up.
•.
The compressor will switch on approximately 3 minutes after the device has been switched on.
•.
Once you switch the device off, wait approximately 3 minutes before switching the device back on.
•. Use.the.air.exhaust.openings.(4).to.adjust.the.direction.of.the.airflow..
•.
Push the key (26, 34) to select between the operating modes “Cooling“ (
COOL
), “Dehumidify“ (
DEHUM
) and
“Fan ” (
FAN
).
b) Cooling (COOL)
•.
Select the operating mode “Cooling“. The indicator light
COOL
(21) will light up.
•.
Push the keys (29, 41) or (28, 38) to adjust the temperature from 16 °C to 31 °C.
•.
Push the key (31, 40) to set a high or low fan speed. With high fan speed, the indicator light
HIGH
(16) will light
up. With low fan speed, the indicator light
LOW
(17) will light up.
The cooling function shuts off automatically if the room temperature is lower than the set temperature.
The indicator light
COMP
(15) will go out. Once the room temperature increases, the cooling function
switches on automatically.
