![background image](http://html1.mh-extra.com/html/conrad/1538154/1538154_operating-instructions-manual_2654649049.webp)
Example: Activate alarm when the indoor humidity drops below 30%
• Briefly push the “ALM” button. “HI AL” appears in the display.
• Briefly push the button “ALM” again; “LO AL” appears in the display.
The alarm mode “HI AL” must be used when an alarm is to be output if the measured
value exceeds the value set by you.
The alarm mode “LO AL” must be used when an alarm is to be output if the measured
value undercuts the value set by you (this is the case in the example used!).
• Briefly push the button “SET” repeatedly until the value for the indoor humidity flashes.
Set a value of 30% with the button “+” or “MIN/MAX” (for quick adjustment, keep the respec-
tive button pushed).
• While the value flashes, the alarm can be switched on (icon “
” appears in the display
of the weather station in the outdoor sensor area) or off (icon disappears) by briefly pushing
the button “ALM”.
•
There are three ways of leaving the setting mode as described above:
-
Push the button “SET” briefly repeatedly until the regular display appears again
-
Briefly push the button “SNOOZE/LIGHT”
- Wait for 10 seconds without pushing any button
49