Record output:
The two pairs of record outputs connect the selected
signal to your recorders or external processing loop (eg. equalizer). The
output signal is not affected by the level control. Connect "record out" to
the
inputs
of your tape recorders or external processors.
Main output:
Connect this output to the input of your amplifier(or
crossover in a bi-amped system). We recommend the use of an amplifier
with an input impedance of 20k ohms or higher.
C
ONTROLS
PHONO, TUNER, CD, VIDEO, TAPE 1:
This selector switch is used to
choose an input. The selected source will be available at the source
position of the tape monitor switch and at both record outputs. Note that
dubbing between tape decks is possible only from tape 1 to tape 2. Also,
since tape deck 1’s output is fed back to its own record input, care must
be taken not to select Tape 1 while the tape deck is in record mode.
Similarly, if tape loop 1 is used for an external signal processor, Tape 1
should never be selected (and, of course, there is no reason to select it
since the external processor is not itself a program source). Failure to
observe these precautions will create an unstable feedback system and
may generate a "howling" sound.
TAPE 1, SOURCE, TAPE 2
: This monitor switch allows you to listen to
either of two tape decks or the source selected by the selector switch.
This control also permits the user to listen to a tape as it is being
recorded. The tape deck will record whichever source has been se-
lected, and the quality of the recording can be monitored by switching
between Source and Tape 1 or Tape 2. Remember-do not select Tape 1
on both switches at the same time. The resultant feedback may damage
your system.
REV, STEREO, MONO:
The setting of this switch does not alter the
signal at the record outputs. Reverse passes the left channel input to
right channel output and vice-versa. Stereo gives normal stereo opera-
tion. Mono passes the sum of left and right inputs to both channel
outputs.
BALANCE:
Permits continous control of location of stereo image from
left to right. In the full counterclockwise position only the left channel will
Sonographe SC1 Owner’s Manual
4
