Conrad Electronic 75 10 74, Operating Instructions Manual

Page: 56 / 148

Universal access, resetting codes
If you have forgotten your master code, or it no longer seems to
function, then perform the following steps.
- Remove your code lock from the power supply
- Move jumper DAP (8) from „OFF“ to „ON“
- Reconnect the main power supply to your code lock (a perma-
nent beep sounds)
- Now move jumper DAP (8) from „ON“ to „OFF“ (the beep tone
mutes) The master code has now been reset to „0000“.
- You are now in programming mode and can make all required set-
tings. Please take these settings from the chapter „Programming
explanation“ in this instruction.
Optical and acoustic indication
Status: Beeper: „MAIN“ LED:
1. In Programming mode off illuminates
2. switch operations 1 x beeping flashing 1 x
3. correct Code-entree 2 x beeping flashing 2 x
4. Wrong Code-entry 5 x beeping flashing 5 x
5. DAP-Jumper is while permanent all two seconds
of the mains voltage on beeping at the a flashing
„ON“ Base station
6. standby mode off all two seconds
a flashing
7. Output is activated 1s Beep sound
The entry and activation sounds can be switched on and off (see
programming mode 81 and 83).
56