Fixing the loudspeakers.
Decide on the location for the loudspeakers (
see below and figure 3, Page 22
) and fix them to
the wall using the brackets supplied and, at the same time, attach the safety eye to the wall
and secure to the speaker using the safety cable supplied.
When positioning the fixing ‘eye’
MAKE SURE THAT THERE IS LITTLE OR NO SLACK IN THE SAFETY WIRE, BETWEEN
THE SPEAKER AND THE WALL FIXING.
Remember, when installing speakers for a Hall Soundfield System,
try not to “think sound”, but try to “think light”.
Imagine that your intention is to give an even spread of
light
throughout the Hall, and
place the loudspeakers accordingly.
Typically, for a 6-speaker system in a rectangular Hall, locate a speaker on to the longest wall
half way between the two end walls and then two more on the same wall at a distance
approximately 1/3 the total length of the hall away from the centre speaker, one to the left and
one to the right hand-side. Repeat for the opposite wall.
Speakers should be fixed at between 3m and 4m from the floor.
Once you have attached the speaker to the
bracket and connected the wires ‘aim’ the speaker
at a point roughly equivalent to a point just in-board from the angle where the floor and the wall
opposite meet. Using the tool supplied, tighten the locking ring to fix the speaker in place.
See figure 3 Page 22
Using the drum of speaker cable supplied connect up the loudspeakers, as per the notes and
drawing (
see page 21
) supplied. Bring the wires back to the wall cabinet for connection to the
output terminals on the rear of the amplifier, passing through the cable entry point in antenna
mounting plate.
- 23 -
CONNEVANS LIMITED Bridge House, 1 Nutfield Road, Merstham, Surrey RH1 3EB
Tel:
01737 247571
Minicom:
01737 644016
Fax:
01737 223475
B40SFSYS2K v3.0 08/2012
Summary of Contents for 40SFSYS 24
Page 2: ......
