2
Connects2
Vision
www.c2vision-eu.com
CONTENTS
• Camera with brake light housing, 2x mini 4pin Male connectors and brake
light wiring
• 2x mini 4pin Female connectors to 1x 7pin Female aviation adapter
• 10m Male 7pin to Female 7pin extension cable
• 7pin Male aviation connector to 2x Female 4pin connectors
(1x Yellow, 1x Black)
• 2x 4pin Male aviation connectors to 2x Female RCA’s
(1x Yellow, 1x Black)
• 2x DC power cables with Male DC connector to bare wires
• 2x Male to Male RCA adapters
• 2x Self-tapping screws
• 2x Plastic end-caps
• 3M camera shaped foam pad
• Instructions
INSTALLATION
1. Measure roughly where the camera will be placed, ensure that the area is
free from all cables, fuel & oil. Then mark/cut the vehicle for the threading of
cables into the vehicle.
2. Place the 3M tape and place the camera on top. Thread the wires and then
proceed to screw into place with the self-tapping screws.
3. Connect the two power wires found on the camera to the following:
Black wire to a suitable ground. Red wire to a sw12V supply.
4. Connect the 2x mini 4pin connectors on the camera to the corresponding
connectors found on the 7pin adapter.
5. Connect the 7pin connector to the 7pin on the extension cable and thread
through the vehicle.
6. Attach the remaining 7pin connector from the extension to the 7pin to dual
4pin adapter.
7. Take the 2x 4pin connections and attach both the 4pin connectors found on
the RCA/DC split wire.
8. Use both the DC power cables to plug into the black connector and
proceed to wire the red to a source of 12V and black to a source of ground.
9. Use the RCA adpater to plug into the yellow RCA on the harness, and
proceed to plug this into the aftermarket accessory’s video input(s).
10.
Test the camera connection by turning on the ignition. The rear camera
feed should now be visible on screen. Put the vehicle into reverse and the
reverse camera feed will automatically populate on screen.
If camera feed is unresponsive, please uninstall the wiring and reinstall carefully
in accordance with the above steps.
11. The camera will be default with parking guidelines. To remove this, simply
cut the green wire found on the camera’s connector.
For further help and support, please contact us directly at
support.connects2.com/tickets/technical
and fill out a support ticket with the full details of your issue.
