www.connects2.com
2
Connects2
Vision
CONTENTS
- Camera with 3m cable to Male 2.5mm plug
- Adhesive pad and fitting accessories
- 8m camera connection cable with Female 2.5mm socket to RCA Male
connector, power, ground and image adjustment wire
- Instructions
INSTALLATION
1. Connect the Black wire to a suitable ground and the Red wire to a switched
+12V supply.
2. If the camera is to be used in the rear of the vehicle, the Red wire should
be connected to the reversing light circuit or an interface which provides a
reverse signal.
3. If a mirror image view is required, do not connect the Green wire on the
camera connection cable to ground. Connecting the Green wire to ground
will provide a normal image view.
4. Select a suitable location for the camera and ensure that the area is free
from all cables, fuel & oil. Whenever possible, avoid locations that are subject
to road dirt & water spray.
5. Remove the screw located in the camera housing cover, remove the
housing cover and then remove the camera.
6. Attach the camera housing to the vehicle using the adhesive pad and fitting
accessories. Ensure that the camera housing is securely mounted to the vehicle
and refit the camera, camera housing cover and screw.
7. Connect the camera cable to the 8m camera connection cable and
connect the connection cable to the display screen and ensure that the im-
age is displayed correctly.
8. Adjustment of the camera may be required to ensure that the correct angle
of the image is achieved. If adjustment is required, loosen the screw located
in the camera housing, adjust the camera and tighten the screw to lock the
camera in position.
Subscribe to our YouTube Channel for installation
guides and tips...
www.youtube.com/connects2
