ConnectedIO ER200T, Instructions Manual

Page: 31 / 34

© 2018 – Connected IO, Inc. 31 | P a g e
13. FCC General Warning
This equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try and correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION:
Any changes or modification no expressly approved by the grantee of the device could void the user’s
authority to operate the equipment.
RF exposure warning
This equipment must be installed and operated in accordance with provided instructions and the antenna(s)
used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons
and must not be co-located or operating in conjunction with any other antenna or transmitter. End-users
and installers must be provided with antenna installation instructions and transmitter operating conditions
for satisfying RF exposure compliance.
Detachable Antenna:
This M2M Router device, ER2000T-NA-CAT1 and ER2000T-VZ-CAT1, integrates an LTE (4G) and WiFi
radio function. Is uses an external antenna (dipole antenna) and a standard antenna connector (SMA type)
which is not covered under FCC 15.203 requirements. Therefore, this equipment needs to be installed by a
professional technician since the M2M application usually resides inside other equipment where the end-
user cannot change the external antennas easily. There is no doubt that the antennas can be replaced by the
end-user once installed in the final configuration.
This radio transmitter FCCID: 2AMRIER2000TNAC1 has been approved by FCC to operate with the
antenna types listed below with the maximum permissible gain and required antenna impedance for each