2.
The remote control is powered by inserting 2 x AAA batteries into the compartment on the
reverse of the remote.
3.
Switch each speaker on by pressing the Power
button on top of each speaker. A blue LED light
will illuminate when each speaker is switched on.
4.
To protect the transmitter and ensure low
power consumption, the transmitter will
cut off automatically if there is insufficient
audio input from the source. Once sufficient
signal is restored, the speakers will automatically
switch on.
*Please Note – you can use standard alkaline or suitable rechargeable batteries. However, the unit does not recharge batteries.
Operation
1.
Turn on the audio source to which the transmitter is connected with. The Signal LED on transmitter will
light up. IF it does not, check an audio output is present.
2.
Select a channel of the transmitter. You can switch channels for best performance in your location.
3.
Press the “POWER” button on the speaker to turn on the speaker. Press the “TUNE” button to get the
best tuning reception for the speakers. When the button is pressed, frequency tuning starts
automatically and it stops when a signal is detected.
4.
Volume can be increased from the speaker by pressing “ + ” button or decreased by pressing the button
“ – “.
5.
Tuning
a)
Keep a distance of approximately 7 meters between speaker and transmitter, and then press the
TUNE button for the speakers to find the best reception.
b)
If no signal has been detected, change the channel at the rear of the transmitter and press the
TUNE button once again.
Note:
