Assembly Instructions:
1.
Remove all protective film from the parts, taking care to avoid scratching the surfaces
2. Determine the size (width and height) of the shelving area.
3. Use the stud sensor to find the first one and mark it using a pencil or chalk. Then, find
the other studs. You need at least 2 studs to hang shelves, but 3 would be better for
length of 1500mm & up.
4. Put the triangular bracket against the wall and mark the screw holes. Use the level to
mark screw holes at the correct location on the other stud(s).
5. Attach one triangular bracket to the wall. First make a hole of the same size as the
screw using the drill, then hold the bracket against the wall and attach with screws. Do
the same with the other triangular bracket(s). Make sure the screw holes are aligned
(they should be if step 3 is done correctly).
6. Put a thin layer of silicon on the top of all brackets and lay the shelf on the brackets,
then use provided Philips screws and nuts to secure the shelf through the pre-drilled
holes on both side of the shelf.
