GraphiteVPX/GbE 16+4-Port - Managed Carrier Ethernet Switch
Users Guide
Document: CTIM-00461
Revision: 0.02
Page 15 of 26
Connect Tech Inc. 800-426-8979 | 519-836-1291
Date: 2016/10/27
Web Management Interface
The GraphiteVPX/GbE 16+4 - Port - Managed Carrier Ethernet Switch allows users to configure and monitor
the device from any web enabled device. Below describes how to access this management interface as well as
provides on overview on the web GUI itself.
Accessing the Web Management Interface
There are two ways to access the web interface for first time use.
Method #1 - Using the default shipping IP
This method DOES NOT require having access to the CLI interface. By default the GraphiteVPX/GbE will
have an IP address of
192.168.42.1
, if you would like to connect to this address follow the steps below:
o
Directly connect any port of GraphiteVPX/GbE to your host PC using a standard Cat5e ethernet
cable
o
Setup your host PC’s IP address to be on the same subnet as GraphiteVPX/GbE (192.168.42.X)
o
Open a web browser and go to the 192.168.42.1 address.
o
Now you should see the login screen and from here you can setup the GraphiteVPX/GbE to an IP
address on your network.
Method #2 – Changing the GraphiteVPX/GbE IP to one on your network via the CLI
This method requires having access to the CLI interface through means of the external management serial port
or the PCIe/104 bus
o
Login to the CLI interface
o
Type in the following commands
o
configure terminal
o
interface vlan 1
o
ip address xxx.xxx.xxx.xxx 255.255.255.0
o
end
o
Now connect GraphiteVPX/GbE to any place on your network.
o
Once the system is up simply go to your specified address of xxx.xxx.xxx.xxx in a web browser of
your choice and you will see the login screen for the web interface
Login Screen of Web Management Interface
To login into the web management interface, the default login is
admin
and the password is blank.
(See below)