4-2
Top Replacement:
1) Place top approximately ¾” from front bezel
on top of unit.
2) Press forward, aligning lip of front bezel with
groove in top and side clips with tabs on cast-
ing.
3) Re-install screws.
Slide top forward.
4.3.2 Bezel Removal and Replacement
Bezel Removal:
1) Remove Top.
2) Remove two flat-head screws on side of bezel
and two pan-head screws on bottom of bezel.
3) Unlatch display ribbon cable, dispersive elec-
trode connector, ReadiPlug™ cable connector
and two ground connectors.
4) In most situations, it is not necessary to
remove the four power switch connectors.
The bezel can be rotated off to the right side
for output board removal. To fully remove the
bezel, these connectors must be disconnected.
Spring contacts are exposed and
can be deformed, causing erratic
operation. Handle with care.
AC Power Switch
White
Blue
Black
Brown
Insulating Sheet
Bezel Replacement:
1) Connect power switch connectors as shown,
if required.
2) Connect dispersive electrode connector and
ReadiPlug™ cable connector prior to sliding
bezel into place.
3) Slide bezel into unit. As shown in figure, the
output board insulator is positioned between
the sheet metal base and the Output Board.
4) Reconnect cables and replace and tighten
screws.
