9 CONGLOMKB .COM
Please contact
or
1-877-333-0098
for further assistance .
ENGLISH
Installation (continued)
10 . The ventilation fan should be connected directly to the switch
through flexible, armoured or nonmetallic sheathed copper cable.
Allow some slack in the cable so the appliance can be moved if
servicing is ever necessary .
11 . A UL listed or CSA approved conduit connector must be provided
at each end of the power supply cable .
12 . Wire size must conform to all local codes and ordinances . The
latest edition requirements of the National Electrical Code ANSI/
NFPA 70, or the latest edition CSA Standards C22.1-94, Canadian
Electrical Code Part 1 and C22.2 No. 0-M91.
WARNING – TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK, OR INJURY TO PERSONS, OBSERVE THE
FOLLOWING:
Installation work and electrical wiring must be
done b
y qualified person(s) in accordance with all applicable
codes and standards, including fire-rated construction.
DANGER:
Risk of electrical shock . This ventilation fan must be
properly grounded .
DANGER:
Turn off the power circuit breaker or the power switch
on the junction box before installing this unit . Touching circuitry
inside the ventilation fan while it is energized will result in
death or serious injury .
DANGER:
All electrical wiring must be properly installed,
insulated, and grounded . Improper insulation and grounding
will result in deadly electrical shock .
IMPORTANT:
It is the customer’s responsibility to contact a qualified electrical
installer and ensure that the electrical installation is adequate and complies with
the National Electrical Code, or CSA standards, as well as all local codes and
ordinances.
-
Install a cable clamp (not supplied) to the wiring hole of the
fan housing in either of the two available locations as shown in
figure 9.
-
Feed the electrical supply cable through the cable clamp . See
figure 9.
-
Use UL approved connectors to connect the fan wires to your
electrical supply cable as shown in figure 10.
-
Tighten the cable clamp to secure the electrical supply cable .
-
Reinstall the electrical wiring junction cover to the fan housing
ensuring all wiring connections are fully enclosed. See figure 11.
Fan Housing
Switch Box
120 VAC Line In
ON/OFF Switch
(Not Supplied)
= Black
= White
= Ground (Bare)
Cable
Clamp
Motor
Receptacle
Electrical Wiring
Junction Cover
Fan Housing
Motor
Receptacle
Cable Clamp
Fig . 10
Fig . 9
Fig . 11
