Copyright
©
2015
congatec
AG
QKIT_IoTq12
3/5
Hardware Setup
Steps:
•
Install the congatec passive cooling solution or an appropriate
conga-QA3 cooling solution.
•
Attach the conga-QA3 Qseven module with congatec passive cooler
to the conga-eNUC/Qseven IoT evaluation board.
•
Connect the twin connector end of the LVDS cable to the evaluation
board (LVDS & backlight) and the single connector end to the display
panel.
•
Connect one end of the touch controller cable to the USB header on
the evaluation board (bottom side) and the other end to the display
panel.
•
Connect other required peripherals.
•
Plug in one end of the DC_IN adapter cable to the 5V power supply.
To power on the system, plug in the other end of the DC_IN adapter
cable to the evaluation board.
conga-QKIT/IoT Interfaces and Functionality Overview
Top Side
Bottom Side
5V Power Supply
PN: 10000151
DC_IN Adapter Cable
PN: 500016
WLAN Pigtail Cable
PN: 14000012
Touch Controller Cable
PN: 14000158
Touch Controller
PN: 10000153
conga-eNUC/Qseven IoT
(PN: 077601)
+
Qseven Module
(PN: 615102)
+
Passive Cooling Solution
(PN: 015192)
LVDS Cable
PN: 14000143
Display Cable
PN: 10000147
DisplayPort
USB 3.0
eSATA
Gbit Ethernet
LVDS EDID
EEPROM
TPM 1.2/2.0
Qseven Module Connector
Internal Display (L
VDS, Backlight ....)
SIM Slot
PWR
1)
(NC)
GND
+5V
RESET, FAN
Encrypted
EEPROM
2x Internal USB
Speaker
Audio
MIC/HP
mSATA module
Sentinel HL
HSPA/LTE
or
I/O module
3)
Wifi + BT
module
3)
CR 2032
Battery
