Congatec conga-PA3, User Manual

Page: 29 / 44

Copyright © 2015 congatec AG PA3Cm01 29/44
5.9 MIPI-CSI 2.0 (Camera)
The conga-PA3 provides a camera interface on connector X55. The interface supports up to two independent cameras - four data lanes for the
first camera and one data lane for the second camera. Each lane operates at up to 1 GT/s depending on the camera resolution. It also supports
up to 24 MP image capture @ 15fps, full HD 1080p60.
The MIPI-CSI-2 interfaces follow the MIPI Alliance CSI-2 specification and support YUV420, YUV422, RGB444, RGB555, RGB565, RGB888, JPEG
and RAW 8/10/12/14.
The table below shows the conga-PA3 MIPI-CSI 2.0 pinout description. The pinout and voltage levels comply with the SGET Camera Feature
Specification.
MIPI-CSI 2.0 (Connector X55) Pinout Description
Pin Signal Description
1 CAM_PWR 3.3V +/- 5% supply voltage to power the camera device
2 CAM_PWR 3.3V +/- 5% supply voltage to power the camera device
3 CAM0 CSI2 Camera 0 Data Lane 0+
4 CAM0_CSI_D0- CSI2 Camera 0 Data Lane 0-
5 GND
6 CAM0 CSI2 Camera 0 Data Lane 1+
7 CAM0_CSI_D1- CSI2 Camera 0 Data Lane 1-
8 GND
9 CAM0 CSI2 Camera 0 Data Lane 2+
10 CAM0_CSI_D2- CSI2 Camera 0 Data Lane 2-
11 CAM0_RST# Camera 0 Reset (low active)
12 CAM0 CSI2 Camera 0 Data Lane 3+
13 CAM0_CSI_D3- CSI2 Camera 0 Data Lane 3-
14 GND
15 CAM0_ CSI2 Camera 0 Differential Clock+ (Strobe)
16 CAM0_CSI_CLK- CSI2 Camera 0 Differential Clock- (Strobe)
17 GND
18 CAM0_I2C_CLK Camera 0 Control Interface, CLK
19 CAM0_I2C_DAT Camera 0 Control Interface, DATA
20 CAM0_ENA# Camera 0 Enable (low active)
21 MCLK Master Clock. May be used to drive camera's internal PLL (19.2MHz or 25MHz)
22 CAM1_ENA# Camera 1 Enable (low active)
MIPI-CSI 2.0
(Connector X55)