Copyright
©
2016
congatec
AG
IA40m12.indd
78/97
Feature
Options
Description
USB Mass Storage Driver Support
Disabled
Enabled
Enable or disable mass storage driver support.
Port 60/64 Emulation
Disabled
Enabled
Enable or disable I/O port 60h/64h emulation support.
Note:
Enable this feature for the complete USB keyboard legacy support for non-USB aware operating systems.
USB Transfer Timeout
1 sec
5 sec
10 sec
20 sec
Set the timeout value for control, bulk, and interrupt transfers.
Device Reset Timeout
10 sec
20 sec
30 sec
40 sec
Set USB legacy mass storage device start unit command timeout.
Device Power-Up Delay Selection
Auto
Manual
Select whether the delay time for a USB device to report itself properly to the host controller should be set
automatically or manually. If set to ‘Auto’, the delay is 100ms for a root port or the value is derived from the hub
descriptor for a hub port.
Device Power-Up Delay Value
Default:
5
0 - 40
Set power-up delay value in seconds.
SanDisk Cruzer Micro 8.01
Auto
Floppy
Forced FDD
Hard Disk
CD-ROM
Select mass storage device emulation type:
‘Auto’ - Enumerates devices according to their media format.
Note:
Drives without media will be emulated according to the drive type.
8.4.26
Security Configuration
Feature
Options
Description
Relay Interface
Disabled
I2C
SMBus
BC Diagnostic Console
Select the relay interface to which the POST code will be redirected.
Primary port Addr.
Lowbyte (Dec)
0-
128
Set the Address for the primary debug port. The usual address value is 0x80. However, any multiple
of 8 is valid for a primary debug port address, i.e. the lower three bits must be zero.
Primary port Addr.
Highbyte (Dec)
0
-128
Set the Address for the primary debug port. The usual address value is 0x80. However, any multiple
of 8 is valid for a primary debug port address, i.e. the lower three bits must be zero.
Relay Device Address (Dec) 0-256
Specify the I2C/SMBus device Address of e.g. a 7-Segment LCD. The factory setting for the
SparkFun device is 0xE2. However, any even device address (bit 0 = 0) can be specified.
BC Diagnostic Console
Interface
Disable
BC AUX Port
Select the interface to be used for the BC Diagnostic Console output or disable the BC Diagnostic
Console output.
