Copyright
©
2017
congatec
GmbH
PA50m112
36/48
5.8
MIPI CSI-2 (Camera)
The conga-PA5 provides a camera interface on connector X1. The interface supports up to two independent cameras – four data lanes for the
first camera and two data lanes for the second camera. Each lane operates at up to 1 GT/s depending on the camera resolution. The interfaces
follow the MIPI Alliance CSI-2 specification and support up to 24 MP image capture @ 15 fps, full HD 1080p60, YUV420, YUV422, RGB444,
RGB555, RGB565, RGB888, JPEG and RAW 8/10/12/14.
The table below shows the conga-PA5 MIPI CSI-2 pinout description. The pinout and voltage levels comply with the SGET Camera Feature
Specification.
Table 22 X1 Pinout Description
Pin Signal
Description
1
CAM_PWR
3.3V +/- 5% supply voltage to power the camera device
2
CAM_PWR
3.3V +/- 5% supply voltage to power the camera device
3
CAM0
CSI2 Camera 0 Data Lane 0+
4
CAM0_CSI_D0-
CSI2 Camera 0 Data Lane 0-
5
GND
6
CAM0
CSI2 Camera 0 Data Lane 1+
7
CAM0_CSI_D1-
CSI2 Camera 0 Data Lane 1-
8
GND
9
CAM0
CSI2 Camera 0 Data Lane 2+
10
CAM0_CSI_D2-
CSI2 Camera 0 Data Lane 2-
11
CAM0_RST#
Camera 0 Reset (low active)
12
CAM0
CSI2 Camera 0 Data Lane 3+
13
CAM0_CSI_D3-
CSI2 Camera 0 Data Lane 3-
14
GND
15
CAM0_
CSI2 Camera 0 Differential Clock+ (Strobe)
16
CAM0_CSI_CLK-
CSI2 Camera 0 Differential Clock- (Strobe)
17
GND
18
CAM0_I2C_CLK
Camera 0 Control Interface, CLK
19
CAM0_I2C_DAT
Camera 0 Control Interface, DATA
20
CAM0_ENA#
Camera 0 Enable (low active)
21
MCLK
Master Clock. May be used to drive camera's internal PLL (19.2MHz or 25MHz)
22
CAM1_ENA#
Camera 1 Enable (low active)
23
CAM1_I2C_CLK
Camera 1 Control Interface, CLK
X1
