Installation
• Position the appliance and allow it to stand for two to three
hours before it is turned on for the first time to allow the
system to settle� Do not position next to any heat source e�g�
cooker, boiler or in direct sunlight etc�
• Allow at least 10cm of space at the top and 10 cm of space
on both sides of the appliance and between the back of the
appliance and the wall for adequate air circulation� The appliance
is not designed for recessed installation (“building in”)�
• Install on a good firm level surface, and any unevenness
of the floor should be corrected prior to installation, slight
unevenness can be overcome by adjusting the front feet�
NOTE:
1� If the appliance is positioned on a carpet, soft floor covering you
should readjust the front feet once the appliance has had time to
settle�
2� If the refrigerator couldn’t through the room door smoothly, you
can remove the refrigerator door at first�
a� Closing the freezer door and removing the top hinge A, then
tearing down the wire gently�
b� Turning the screw of hinge B anticlockwise to remove hinge�
Be careful don’t let the door falling off�
c� Lift the door vertical and remove the door from hinge C�
d� Repeat point a to c for fridge door�
e� You can reinstall the freezer and refrigerator door in the
reverse order of removal as above�
CAUTION
During dismantling, please note to lift the door
vertical to avoid the hinge damaged. Don’t crush the wire
of door. Put the door at the right place to avoid scratch
and damage.
Use
• This appliance is designed to operate in ambient temperature
between 10°C and 43°C� If these temperatures are exceeded,
i�e� colder or warmer, the appliance will not operate correctly�
41
40
GB
GB
