Optional mounting method when deck height is
greater than (54-1/2) inches.
Adjust the height of the entry system so that the top
step, at minimum, reaches the face board of the deck,
however, the height of the bottom surface of the top step
must not exceed (54-1/2) inches. Cut a piece of 2 x 4
pressure treated lumber (28-1/4" long) and place it edge
down on the top step between the two flanges of the
side panels. Secure in place with four #10 x 1-1/4"
screws (not provided) through the two lower holes in
each of the mounting flanges of the side panel. After
securing the 2 x 4 to the unit, position the unit so that
the 2 x 4 meets the face board of the deck. It can then
be secured in place using wood lag screws. Three 2-1/2"
long lag screws are required (Lag screws not provided).
6
2" x 4" x 28-
1
/
4
" LONG
2-
1
/
2
" LONG LAG SCREWS
#10 x 1-
1
/
4
" LONG
SELF-TAPPING SCREWS
Order online @ www.conferladders.com
PES-1 / PES-DBL 5M 12/07
Printed in U.S.A.
Removal and storage of Pool Entry System:
In cold climates the Entry System must be
removed from the pool and drained to prevent
freezing and cracking. To remove the unit discon-
nect it from the deck (or the outside unit), pull
large plugs and tip it so that some of the water
drains from the large fill openings. Once the unit
is lighter it will become buoyant so that it can be
turned onto its side and the bottom drain caps
and plugs can be removed. With the unit on its
side, slowly pull the Entry System from the water
allowing the water to drain out of the unit. Once
the unit is out of the pool be sure that all the
water drains out. If desired the unit can be disas-
sembled for winter storage. Use a flat blade
screwdriver to remove the locking wedges and
carefully pull the side panels away from the steps.
(Be sure to save all caps and locking wedges
for reassembly).
OPTIONAL ACCESSORY
SKIM-IT
—SKIMS OFF DEBRIS.
Cut cleaning time 75% with skimmer extension
that guides debris directly into your skimmer.
Fits most in-ground and above-ground pool
skimmers. Corrosion-resistant plastic Skim-It
installs in seconds without tools.
DECK FACEBOARD
CONFER PLASTICS, INC.
LIMITED, PRO-RATED WARRANTY
Confer Plastics, Inc. warrants their swimming pool ladders to be free from defects in workmanship for one year from
date of purchase. After the first year the cost to replace a part is as follows:
POOL ENTRY SYSTEM
2
nd
Year - 20%
3
rd
Year - 40%
4
th
Year - 60%
5
th
Year - 80%
Plus shipping/handling
Enclose proof-of-purchase (receipts, etc.) showing date purchased, your name, address, and daytime phone number. You
will be notified of cost to replace part.
This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state.
DO NOT RETURN DEFECTIVE PART TO DEALER
The defective part should be returned, postpaid, to:
Confer Plastics, Inc.
97 Witmer Road
North Tonawanda, N.Y. 14120-2421
of current parts
list price
