17.
Position the tread connector as shown,
with the padlock hole facing upward, and
tap it over the round knob. Repeat for the
opposite tread connector.
Tap the tread connectors onto the ends
of the treads until they are firmly seated.
15.
16.
Position the four “swing up” treads
onto the ladder legs as shown.
4
14.
Attach the two remaining standard
treads to the extension boots (or directly
to the ends of the ladder legs if installing
on a 48” tall pool).
Snap Small and Large Barrier Sections
into slots on Lower Base as shown.
Separate Barrier sections at the top
slightly and position Upper Brace over
Small Barrier Section. Next, spread the
“fingers” on the Upper Brace and slide
into position on the Large Barrier Section.
Fingers
18.
19.
20.
Place the Base and Brace into position, centered,
on the bottom and fourth treads of the ladder.
Install the four (4) #10 x 1-1/4" screws (included in
hardware pack) on a slight angle, first in the
Upper brace, then in the Lower Base. Install the
self-adhering foam strips to the Large Barrier
Section as shown in diagram.
Foam
Pads
“Swing” up portion of ladder shown
in “down” position and the padlock
in the “holding” area.
Swing up portion of ladder shown in
“up” position, secured with padlock.
21.
22.
Screws
Large
Barrier
Small
Barrier
If Ladder
did not include Barrier, skip steps 18 through 20. Continue to step 21.
