background image

MODEL CK7100-X Conversion Kit

 

(warm gray)

USE CK7100-X CONVERSION KIT TO CONVERT 

7100X A-FRAME

 LADDER TO 

6100X INPOOL

 LADDER

ASSEMBLY, INSTRUCTION AND USE MANUAL

Parts List

2 - Adjustable Tube Handrails (wg)
2 - Mounting Block (wg)

1.

7100X A-Frame Ladder

2.

3.

Swing-up section removed.

To reduce the risk of drowning, entrapment, falls, paralysis, electrocution, or 

other serious injury or death: 

Dealer/Installer:

 Give manual to homeowner.

Installer:

 Read 

"Safe Installation"

 below and all instructions before beginning. For proper assembly and 

installation, instructions must be followed completely. 

Homeowner:

 Read 

"Safe Use"

 on back cover before using. Save these instructions.

Installation must comply with local codes and may require permits.

S

Proudly Made in U.S.A. by

Safe Installation

To reduce the risk of electrocution, drowning, entrapment, falls, or other serious 

injury or death: 

Check building codes/permitting. 

Consult your local Building Department before installation of your pool and 

equipment. Pool/equipment installation must comply with the codes of the authority having jurisdiction and may require 

permits (e.g., building, plumbing, electrical, zoning, etc.). Be sure that barriers (fences, gates, etc.) restricting pool 

access meet local codes.

Use for intended purpose only

•  Use only as conversion kit for ladder.
•  When converted, this ladder is designed and manufactured for a specific pool wall height and/or deck of the pool - 

check product specification and the height of your pool.

Check that you have all required parts. 

Check the contents of the carton with the Parts List for this ladder.  

All parts and hardware are required. If any parts are missing, 

DO NOT attempt to assemble or install the ladder.

 

Instead, call Toll Free U.S. - 800-635-3213 or visit our web site at www.conferplastics.com for assistance.

Select an appropriate location

 - The ladder must be located on a level, solid base and in a location that will be  

in full view of competent adult supervision when in use.

Follow all instructions

•  For stable, correct assembly and installation, all instructions must be followed completely and in the  

sequence shown.

•  Follow the manufacturer’s recommendations for the safe use of all hand tools and equipment used during installation.

Cordless drill only - no corded drills near pool.

 Use a cordless drill for assembly and installation. To reduce the risk of 

electrocution, NEVER use a corded drill in or around a pool.

Lift safely.

 When lifting awkward or heavy loads, have another person help you.

Double check after installation

•  Before using the product, after assembly and installation, go over the instructions and procedures again to make sure 

nothing has been overlooked.

•  Make sure that safety labels are installed and legible.

Using a rubber mallet remove 

the swing-up portion of ladder 

from ladder platform tabs.

5.

Remove the outside ladder 

section by tapping on the 

underside of platform until 

ladder separates.

6.

4.

With a cordless drill, remove 

the (2) two screws from the 

top of hand rails.

7.

Use only 

in pool 

section of 

ladder with 

anti-entrapment 

barrier attached.

Slide tube rails 

up through 

bottom of 

platform until seated on tabs.

WARNING! Using 

a corded drill near 

pool may result in 

electrocution.

2 - Adjustable Tubes (wg)

Hardware Pack

14 - #10 x 1-1/4” screw

Reviews: