2
Step 1.
Step 2.
Step 4.
Step 3.
Using a knife care-
fully remove all
four [4] wedges.
Insert tabs on platform
into handrail. Repeat
for 2nd handrail.
Pour 5 lbs
of sand
into each leg.
Fill remainder
with water.
Install threaded cap
over bottom drain hole.
Step 5.
Step 6.
Insert wedge into handrail just below the
platfom tab, using rubber mallet tap into
place. repeat to install remaining three [3]
wedges into handrails.
CONFER PLASTICS, INC.
Model #635-52X
ASSEMBLY INSTRUCTIONS - PLEASE READ BEFORE ATTEMPTING ASSEMBLY
Parts List
Tools Needed for Assembly
2 - Handrails
* Sand - 10 lbs
1 - Ladder Section
* Cordless Drill Motor
1 - Platform
* 1/8" Drill Bit
* Phillips Screwdriver
Hardware Pack
* Tape Measure
14 - #10 x 1-1/4" Screws
* Liquid Soap or Lubricant
1 - Threaded Cap
2 - Mounting Blocks
2 - Adjustable Tubes
If missing parts call - Toll free U.S. - 800-635-3213 or www.conferladders.com
Adjustable
Tubes
Ladder
Handrails
Mounting
Blocks
Platform
Slide the
handrails onto
the legs.
DO NOT
secure with
screws at
this stage.
