2
Step 1.
Step 2.
Step 4.
Step 3.
Slide the
handrails onto
the legs.
DO NOT
secure with
screws at
this stage.
If needed coat tubes
with liquid soap or
lubricant. Push the
adjustable tubes through
mounting blocks. Push
the adjustable tubes up
into the handrails.
Pour 5 lbs
of sand
into each leg.
Fill remainder
with water.
Install threaded cap
over bottom drain hole.
Adjustable tube
Mounting block
Step 5.
Step 6.
Place the ladder into the pool and position mounting
blocks on deck. Slide the adjustable tubes up or down
as needed until mounting blocks are sitting flush on
the deck. Ladder
MUST
rest on pool bottom. If not,
EB100 riser(s) are required. (See page 3 to order)
Drill four pilot holes (1/8") through holes in
each block into wood surface. Fasten blocks
to deck using the four #10 x 1-1/4" screws per
mounting block. Drill three holes through each
side of each handrail at the pre-marked
locations. Fasten using three #10 x 1-1/4" screws.
Slide down into position
once mounting blocks
have been fastened.
Flush to deck
CONFER PLASTICS, INC.
Model #635-52
ASSEMBLY INSTRUCTIONS - PLEASE READ BEFORE ATTEMPTING ASSEMBLY
Used to raise ladder when deck is built higher
than pool. Maximum 2 risers. Fill with sand and
water, rest ladder on top. Straps included.
Platform provides extra “step” at top of ladder.
Prevents swimmers from stepping on pool top.
3
NOTE:
Check with your dealer for availability first
or order online at:
www.conferladders.com
SKIMS OFF DEBRIS
Cut cleaning time 75% with skimmer extension
that guides debris directly into your skimmer.
Fits most in-ground and above-ground pool
skimmers. Corrosion-resistant plastic Skim-It
installs in seconds without tools.
IMPORTANT
FOR YOUR SAFETY
*
Check the contents of the carton with the Parts list
for this ladder.
*
If any parts are missing call Toll Free U.S. -
866-396-2968 or visit our web site at
www.conferladders.com
*
DO NOT
attempt to assemble or install the ladder
if there are
ANY
shortages of parts or hardware.
*
For proper assembly and installation follow all
instructions in the sequence shown.
*
Before using the product, after assembly and
installation, go over the instructions and procedures
again to make sure nothing has been overlooked.
*
Be sure and safe. The manufacturer
IS NOT
responsible for improper assembly, installation
and use.
Parts List
Tools Needed for Assembly
2 - Handrails
* Sand - 10 lbs
1 - Ladder Section
* Cordless Drill Motor
* 1/8" Drill Bit
Hardware Pack
* Phillips Screwdriver
14 - #10 x 1-1/4" Screws
* Tape Measure
1 - Threaded Cap
* Liquid Soap or Lubricant
2 - Mounting Blocks
2 - Adjustable Tubes
If missing parts call - Toll free U.S. - 866-396-2968 or www.conferladders.com
For winterizing in cold climates remove ladder from the pool, and drain water from ladder.
Adjustable
Tube
Ladder
Handrail
Mounting
Block
ADDITIONAL ACCESSORIES
For #635-52 Ladder
SKIM-IT
EB 100-3" RISER
DK300 DECK KIT
Confer A frame 635-52_R6:Confer A frame 635-52_R1 10/11/07 12:06 PM Page 3
